Porter-cable 340 Manuale Utente

Double InsulatedFinishing SanderInstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers in the

NOTE: A slight twisting action will ease removal and reassembly.Tap container lightly to remove compacted dust. DO NOT WASHCONTAINER. Dry compressed a

11USING THE SANDERSANDING PROCEDUREThe normal weight of the machine is sufficient for efficient sanding. Do notput additional pressure on the machine.

12REMOVING PAINT AND VARNISHCAUTION: Read and follow all instructions in the ADDITIONALSAFETY RULES FOR PAINT REMOVAL section of this manual.Your sand

13Any loss of power before the above maintenance check may indicate theneed for immediate servicing of your tool. DO NOT CONTINUE TOOPERATE TOOL UNDER

14PORTER-CABLE LIMITEDONE YEAR WARRANTYPorter-Cable warrants its Professional Power Tools for a period of one year from the date of originalpurchase.

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

2WARNING: SOME DUST CREATED BY POWER SANDING, SAWING, GRINDING, DRILLING, AND OTHER CONSTRUCTION ACTIVITIEScontains chemicals known to cause cancer, b

32. Dress properly. Do not wear loose clothing or jewelry. Contain longhair. Keep your hair, clothing, and gloves away from moving parts.Loose clothes

4SPECIFIC SAFETY RULES AND SYMBOLS1. Always disconnect the sander cord plug from the power circuit beforechanging abrasive sheets.2. Sanding of lead-b

5ADDITIONAL SAFETY RULES FOR PAINT REMOVALWARNING: Extreme care should be taken when removing paint. Thepeelings, residue, and vapors of paint may con

6MOTORMany Porter-Cable tools will operate on either D.C., or single phase 25 to 60cycle A.C. current and voltage within plus or minus 5 percent of th

7Naturally, in all sanding operations, best results will be obtained if you selectthe proper size and type of abrasives. Only garnet, aluminum oxide a

8Fig. 6 Fig. 7PAPER PUNCHA Paper Punch is provided withModel 340 Sander. The punch isused to make eight holes throughthe abrasive. These holes allow t

OPERATIONTO START AND STOP SANDER1. CAUTION: Make certain the switch is in the “OFF” position, and thepower source is the same as that specified on th